Blackmagic Forum

Up until the latest beta my speed editor seemed to function as expected, but now it only connects through usb.

When connected by usb, the battery reports 99% full.

I can see it in my Bluetooth menu.

I tried using doing a factory reset from the control panel setup without success.

Any ideas?

I found that, during the "looking for control surfaces" period of Resolve's boot sequence, moving the jog wheel or hitting some of the buttons will initiate Speed Editor's connection with Resolve.

Can you see the Speed Editor in Windows Settings?

Did you do a clean install of the latest Beta9. Recommended since Beta 5 to uninstall previous version before installing. Cleared that up for me after Beta 7 that I had just let install.

I'm on a Mac, but I can see the editor in my Bluetooth menu (which I don't think I could before, come to think of it!)

I thought that a clean install was only indicated for Windows, not for Macs, but I guess it's worth a try. Will my projects remain?

Edit:
I removed the editor from my Bluetooth list, and re-launched Resolve. Then I reconnected through the Bluetooth menu, and now it's working again.

Yes I could see the Speed Editor too, paired . It would sometimes work if I touched the buttons before launching Resolve. Now it loads without any input like that.

The projects will remain as they are in the project data base, at least that is true for Windows with nothing lost when uninstalled and reinstalled.