Fusion - Increase width without repositioning
Posted: Sat Feb 27, 2021 8:44 pmIs there a way how to increase a rectangle's width to the right without the extra step of repositioning the center of the rectange?
Need to increse the width of blue rectangle:
Width increased, but now I need to reposition
Repositioned correctly. But with extra reposition step.
Is there a way to anchor the position to Top Left?
Need to increse the width of blue rectangle:
- Step1-SmallRectangle.png (28.47 KiB) Viewed 217 times
Width increased, but now I need to reposition
- Step2-WidthButWrongPosition.png (27.48 KiB) Viewed 217 times
Repositioned correctly. But with extra reposition step.
- Step3-CorrectlyPositioned.png (26.89 KiB) Viewed 217 times
Is there a way to anchor the position to Top Left?