Blackmagic Forum

Hi,

I'm trying to make the jump from Premiere to Resolve as my primary editor (have been using it for grading for years now).

I want to use a TV as a full screen feed while editing but when I switch to "Video Clean Feed" I just get a white full screen with nothing else. Anyone have suggestions?

Note: I do have a video assist which I use to connect my Flanders Scientific for grading, but I'm just doing an HDMI in to my computer for the TV since I'm going for screen size not accuracy here.

Thanks!

Please detail your system and settings? R u using the Studio version?

Peter Chamberlain wrote:Please detail your system and settings? R u using the Studio version?

I'm using Resolve Studio 17 on a 2020 27" iMac with 8GB vram + 8GB vram via the Blackmagic eGPU. The HDMI was plugged from the TV (Sony 720p) into the eGPU then I tried directly into the computer, same results.

I also tried unplugging and plugging in my Flanders Scientific monitor which runs from the eGPU to a Blackmagic assist, to the Flanders. That didn't seem to make a difference.

I haven't tried it without the eGPU but I'm hoping that's not the issue because I probably need that extra kick for the RAW 6k I'm working with.

Let me know if there are any other specific details that would be helpful. Thanks!

Better get an I/O interface and feed the TV or the Flanders from that. Works perfectly fine here for me with a very similar configuration.