Blackmagic Forum

Hi,

I've been working on some basic animation and following the recent updates the animation doesn't actually finish properly? My keyframes are set to gradually fade out, however the ending just cuts short. I fixed this issue yesterday by reducing the animation in duration, however I've loaded the project back up and it's back. Really frustrating, as it took some time to get it back!

Any advice would be greatly appreciated.

Take a look at the appropriate keyframe properties as you advance frame by frame.

I've checked over the keyframes and they look fine to me. Do you have any idea of a fix or setting I might have missed? On the screenshot the keyframes should be working however they just cut out.

No, I mean look at the values of the animated property as you move frame by frame between keyframes.

If X went from 0 to 100, is it at 50 half way through?

Apologies for my lack of understanding, I'm certainly a beginner to keyframes as you can probably tell I can't seem to locate the x value on fusion? I've opened up the spline tab and as you see the values are decreasing on both width and text

As u can see in the vid the width decreases frame by frame, but the elements just cut out