inspector/selection is slowing down resolve drastically
Posted: Sun Apr 04, 2021 9:33 pm
when the inspector is open, there is a very noticable delay in the timeline after every up or down(next or previous clip) command. especially when "selection follow playhead" is turned on. If i close the inspector things are snappy again, but that still doesn't take away the delay when i manually select a clip. It can get up to about a second or 2. I'm pretty sure this wasn't as noticable a few months ago as it is now. Is this normal?
I remember i had the same issue with my previous build, which slowly got worse and worse. even re-installed windows a few times, but didn't improve it. It got up to the point where it was so bad, that i wanted to throw my pc out of the window. i'm now kind of afraid this will happen again. Does anyone recognize this?
i tested this with footage (xavc, mxfop1a, r3d, etc) from both my NAS and my internal m2 SSD.
I remember i had the same issue with my previous build, which slowly got worse and worse. even re-installed windows a few times, but didn't improve it. It got up to the point where it was so bad, that i wanted to throw my pc out of the window. i'm now kind of afraid this will happen again. Does anyone recognize this?
i tested this with footage (xavc, mxfop1a, r3d, etc) from both my NAS and my internal m2 SSD.