Re-enable stripped/disconnected audio

I'm bringing in a Resolve project created by the Atem Mini Pro ISO. Over a 30 minute program there are many cuts. When I open the project, the timeline initially references the MP4 files that that were created by the Atem for each take. If I go into the Cut page and click "Show Camera Originals" then the camera generated raw files are substituted. But the audio is still referencing the MP4 Atem file.

I would like the audio to be the tracks that are part of the RAW camera files instead. I can do this clip by clip if I click on Clip/Match Frame to Source Clip and then do an overwrite. But this is very tedious. Is there way to enable the audio doing a mass select in the time-line without having to do overwrites on hundreds of clips?

Is the only place where you can toggle “Show Camera Originals” in the Cut page? I’ve searched the manual and there is no mention of this functionality to be found.

I’m not sure why toggling this does not bring in the audio connected to the Raw file instead of leaving the MP4 file’s audio in its place.