- Posts: 111
- Joined: Wed Apr 20, 2016 2:11 pm
Fri Jun 25, 2021 2:58 am
I have a Gaomon tablet (similar to the Wacom tablets)
It works like a dream in Photoshop.
However, in Fusion where I draw isn't where it shows on the screen.
To be clear, let's say I have a subject and I draw a line from his/her head to the right with my mouse. Fine. That works great. Use my tablet, and try to draw over that line, it's (maybe) 20 pixels above and to the left (that's not exact. I am just unsure how else to describe it. Point is, I can't draw over the same line. And up and to the left....isn't that from a movie? But I digress...
Again. Tablet is fine. Works in Photoshop. Mouse is fine. I can draw my line exactly where I put my mouse. Tablet in Fusion...it is offset. Thought it may be because I didn't use a Fusion composition. No difference. (in other words, I tried both just going into Fusion after clicking on a clip, and by putting a Fusion comp on the timeline, and then loading the clip in Fusion.
So, er....any ideas?
It works like a dream in Photoshop.
However, in Fusion where I draw isn't where it shows on the screen.
To be clear, let's say I have a subject and I draw a line from his/her head to the right with my mouse. Fine. That works great. Use my tablet, and try to draw over that line, it's (maybe) 20 pixels above and to the left (that's not exact. I am just unsure how else to describe it. Point is, I can't draw over the same line. And up and to the left....isn't that from a movie? But I digress...
Again. Tablet is fine. Works in Photoshop. Mouse is fine. I can draw my line exactly where I put my mouse. Tablet in Fusion...it is offset. Thought it may be because I didn't use a Fusion composition. No difference. (in other words, I tried both just going into Fusion after clicking on a clip, and by putting a Fusion comp on the timeline, and then loading the clip in Fusion.
So, er....any ideas?