Multicam in a vertical timeline cuts off when reframing

Why would this happen?
Is there a way to stop it from happening, I can't see any way that this behaviour is helpful lol

Anyone know a way around this except exporting the whole timeline and resizing it that way?

Try the following steps:

1. Create a new timeline and uncheck the "Use Project Settings" checkbox.
2. In the format tab set the resolution the same as the source clips.
3. Go to the output tab, uncheck the "Use Timeline Settings for Output Scaling" and set the output resolution to a vertical resolution.

Try the following steps:

1. Create a new timeline and uncheck the "Use Project Settings" checkbox.
2. In the format tab set the resolution the same as the source clips.
3. Go to the output tab, uncheck the "Use Timeline Settings for Output Scaling" and set the output resolution to a vertical resolution.

Thanks for the suggestion! Sadly no it didn't work, it just cuts it off at the top and bottom this way

Any progress on this? Hard to believe this could still be a problem but I am experiencing the edges cut off when reframing.

Would you believe that its still a problem in April 2024

I'm having the same issue!!