Blackmagic Forum

Right now if I select UltraNR in the color page on an adjustment clip and hit Analyze nothing happens. I can set the parameters manually and it works. I guess this is a bug?

Not sure its a bug. NR is usually best applied to the clip directly.

Jim Simon wrote:Not sure its a bug. NR is usually best applied to the clip directly.

yes, that is probably correct. I use adjustment clips for stop motion scenes where it would be tedious to enable denoising per image but all images are captured with the same noise. So there are actual usecases for this.

Stop motion clips can be brought in as an Image Sequence to make this kind of thing easier.

Jim Simon wrote:Stop motion clips can be brought in as an Image Sequence to make this kind of thing easier.

last time i tried all images where played back at the same speed which is only useful in some scenarios. but I'll take a look again, thanks