- Posts: 6
- Joined: Thu Jul 30, 2015 3:50 pm
Thu Jul 30, 2015 4:00 pm
Hi,
I did color grade in calibrated DCI P3 cinema projector Christie CP2215. Because some environmental issues the lamp light can only keep in 20fL, we still considered to set up an ND filter to lower the light.
Anyway I still finished the color grading job then exported XYZ 16bit tiff to create DCP by easyDCP creator 3.3. After played the DCP I found the image became darker and the color temperature is lower(yellowing).
The projector setting is XYZ color space/gamma 2.6 and calibrate well, only has the lamp light issue like I said before(too light=20fL).
Could it be possible when I exported XYZ 16bit tiff will keep everything in standard DCI 14fL? So the DCP image s is darker andcolor temperature is going down? Or something else can cause this situation?
I did color grade in calibrated DCI P3 cinema projector Christie CP2215. Because some environmental issues the lamp light can only keep in 20fL, we still considered to set up an ND filter to lower the light.
Anyway I still finished the color grading job then exported XYZ 16bit tiff to create DCP by easyDCP creator 3.3. After played the DCP I found the image became darker and the color temperature is lower(yellowing).
The projector setting is XYZ color space/gamma 2.6 and calibrate well, only has the lamp light issue like I said before(too light=20fL).
Could it be possible when I exported XYZ 16bit tiff will keep everything in standard DCI 14fL? So the DCP image s is darker andcolor temperature is going down? Or something else can cause this situation?