Blackmagic Forum

Hello,

I found a new function into Edit mode. I like the name of this function because it sounds like something I was looking for a long time : to be able to edit separately channels from a 1,2,3,4 or more adaptive audio track (in this capture screen, a 8 channels audio clip into an 8 adaptive audio track).

But This "Display individual audio channels" doesn't seem to change anything... maybe some of you have an idea ?

Best

Robin

The function only displays waveforms for each audio channel contained within the clip, but does not allow editing of the embedded individual channels separately.

Page 480 of the Manual:
“While a single averaged audio waveform representing all the channels in that clip is shown by default, you can switch any clip to seeing each individual waveform in a vertical stack by right-clicking any audio clip and choosing Display Individual Audio Channels.

Whenever you cut an audio clip, you cut all audio channels with it. Audio channels that are embedded within a single track cannot be individually edited.”