Blackmagic Forum

I made a little project, changed to the fusion tab and used the paint tool.
It worked and I could make changes in the inspektor.
I saved the project for later use.
Opening later, the inspektor for the paint tool is empty. The inspector says: <No Object selected>
The paintings are still there and can be deleted, but not changed anymore.
Is that behaviour correct? The Fusion Tool guide does not give an answer.

Hartmut

Yes. That is correct behaviour - in a sense - after you've drawn a stroke, the stroke is placed in the modifier section, leaving only the current (actually the stroke you're about to draw) selected.
You can find all your strokes in the modifier section. You'd have to make the strokes editable to actually change them, unless you created polyline strokes to begin with.

Thanks. I already thought so.
I found the modifier section. It was not so obvious...

Hartmut