Fairlight Bug
Posted: Thu Jun 21, 2018 7:06 pmHere's a bug from way back that's showing up again in 15b5 on Windows 10 Pro (1803).
If I have an End At Cut transition on an audio clip, and I add a cut to that clip, Fairlight will erroneously move that transition to the cut point instead of leaving it at the end of the clip where it belongs. This does not show up on the Edit page, only in Fairlight. But the mix follows the incorrect behavior as shown in Fairlight.
If I make the cut first, then add the transition, it all works normally.
If I have an End At Cut transition on an audio clip, and I add a cut to that clip, Fairlight will erroneously move that transition to the cut point instead of leaving it at the end of the clip where it belongs. This does not show up on the Edit page, only in Fairlight. But the mix follows the incorrect behavior as shown in Fairlight.
If I make the cut first, then add the transition, it all works normally.