Fusion page vs Fusion stand alone: muscle Memory issue
Posted: Sat Jul 28, 2018 7:55 amHi,
I just encountered a muscle memory issue when moving between Fusion standalone and the Fusion page: in standalone there is an arrow on the header of the tool in the tool panel that lets you open up (and close) the settings. In the Fusion page in the same location there is the little red toggle switch that lets you pass through the tools. So it's in the same position, but has a pretty different functionality. I have turned off quite a lot of nodes by accident, because of this.
I just encountered a muscle memory issue when moving between Fusion standalone and the Fusion page: in standalone there is an arrow on the header of the tool in the tool panel that lets you open up (and close) the settings. In the Fusion page in the same location there is the little red toggle switch that lets you pass through the tools. So it's in the same position, but has a pretty different functionality. I have turned off quite a lot of nodes by accident, because of this.