Blackmagic Forum

Posted: **Wed Aug 01, 2018 1:06 am**

Like it's says in the subject, is it possible to only see in the scopes what is inside a mask? For example, I have a MacBetch chart on the image. I want to isolate one of the grey squares and make it neutral. But the scopes will always show the entire image. I would like to just see an isolated view.

Posted: **Wed Aug 01, 2018 1:25 am**

Shift+H will limit the scopes to the masked area.

Posted: **Wed Aug 01, 2018 1:30 am**

Whoohoo! Thanks!

Posted: **Wed Aug 01, 2018 2:06 pm**

Nice tip. Thanks Jack.

Posted: **Wed Aug 01, 2018 11:13 pm**

You can also temporarily use input PTZR to zoom in to the mask, which will fill the screen and also the scopes.

Blackmagic Forum

Scope only show what's in the mask?

Scope only show what's in the mask?

Re: Scope only show what's in the mask?

Re: Scope only show what's in the mask?

Re: Scope only show what's in the mask?

Re: Scope only show what's in the mask?