Blackmagic Forum

Upgrading from DR v14 Studio to DR v15 Studio has seem to broken the sound.
Even new project sound would not work. All the meters were working.
I tried changing devices in preferences, manual control, etc.
It has taken me ALL morning trying to figure this out...

It seems DR v15 can ONLY use a sample rate of 48kHz?
I had to adjust this for my RME UFX before it would work.
I am guessing this is required for all devices?
Can anyone confirm this?

I hope it will eventually allow higher sample rates, as DR v14 Studio was working before.

Anywho, as of now, I have DR v15 Studio working again with my RME UFX.
Though, changing the sample rate to 48kHz has no doubt broken my DAW environment.
I guess I will have to change the sample rate settings back and forth for each app, sigh...

Ed June wrote:Upgrading from DR v14 Studio to DR v15 Studio has seem to broken the sound.
Even new project sound would not work. All the meters were working.
I tried changing devices in preferences, manual control, etc.
It has taken me ALL morning trying to figure this out...

It seems DR v15 can ONLY use a sample rate of 48kHz?
I had to adjust this for my RME UFX before it would work.
I am guessing this is required for all devices?
Can anyone confirm this?

I hope it will eventually allow higher sample rates, as DR v14 Studio was working before.

Anywho, as of now, I have DR v15 Studio working again with my RME UFX.
Though, changing the sample rate to 48kHz has no doubt broken my DAW environment.
I guess I will have to change the sample rate settings back and forth for each app, sigh...

Video is normally 48khz and both software and audio devices have to be clocked at the same sample rate to work together. Most DAWs will set the same rate for the audio device once you start them but Resolve needs setting up manually from the audio devices control panel.