Blackmagic Forum

How do you stretch multiple selected tracks in the edit tab and stretch them?

I could do this in Premiere why can't I figure this out in Resolve 15?

Juan Salvo helped me out.

When you hold the control key down and select each control point, it works!

You can also select by holding down alt-shift and dragging a region.

Just be careful of some inconsistent behavior I'm seeing when selecting edits to do work--

https://vimeo.com/287321829/a25dec19cd

Also how are you embedding that Vimeo link?

Oh, come on, there's a much faster way. Hit "v", then up or down arrow, to go to the next or previous transition, then back to the transition you want to cut. All the clips on that cut will be highlighted and ready to trim, as long as their auto-selectors are on.

John Paines wrote:Oh, come on, there's a much faster way. Hit "v", then up or down arrow, to go to the next or previous transition, then back to the transition you want to cut. All the clips on that cut will be highlighted and ready to trim, as long as their auto-selectors are on.

How about a selection like this hot shot?

https://vimeo.com/287528147/6073b14df2

Dustin Bowser wrote:How about a selection like this hot shot?

https://vimeo.com/287528147/6073b14df2

That's simple. Hold a command key and select all cut as you need. You can select right or left side of each the cut.

Vit Reiter wrote:That's simple. Hold a command key and select all cut as you need. You can select right or left side of each the cut.

But only in Trim mode.... Don't think there's any way to lasso cuts in selection mode.