Blackmagic Forum

I have 4 clips on 4 tracks, each sized and positioned to make a quad split.

I want to rotate each clip at the same time on its Y axis by 90 degrees to reveal a graphic underneath.

With the playhead on the clips, I go to the Fusion tab expecting to see 4 clips but I only get the clip on the lowest track on the Fusion page.

A bit stuck.....

Did you try selecting the 4 tracks and right clicking, choose new fusion clip?

Ok. Now I have 4 clips with merges nodes. But only one clip shows in the Media Out.

EDIT: Changed APPLY MODE to SCREEN in all MERGE nodes. All clips now visible.

Getting closer.


Thanks
This is AMAZING software.