Blackmagic Forum

Great update guys!

Lots of great fixes in there. Keep em coming!!!

How does the new behavior of the Frame Range in the Fusion page operate? I'm still seeing frames in the range I don't want to or need to see.



Ideally the In point is all the way at the left and the out point is all the way at the right, and the only frames I'm seeing are the frames I'm actually working on.

And also, there should be a way to toggle the Frame display so that the start of the range can start from 0 (or 1 as some artists prefer) so that while in the comp we can know what frames we're really working on. Like trying to figure out what is frame 150 or whatever, right now we have to bust out a calculator.

Fusion previously supported the start of a comp at an custom start frame, in most VFX shops a comp starts at frame x1001.

This is not the case in Resolve 15 (havent had time to test 15.1 yet), where the frame range is based on the length of the shot and clip starting from frame 0.

We need to set custom start and stop frame ranges for comps, this has been requested previously.

On the ends of the slider there are slightly darker dots on either side, you can drag those in/out to set zoom level of render range.

Edit: Unless that was always there...then I have no clue...

Right. That functionality has always been there but in 15.1 there is supposedly some updated functionality based on some user feature requests.