- Posts: 3
- Joined: Tue Sep 08, 2015 4:43 pm
Tue Sep 08, 2015 6:15 pm
B-splines will crash my Mac upon creating a 5th vertex (1-4 are okay - it always crashes on the 5th.) It doesn't matter if the b-spline node is connected to another node or by itself. It also doesn't matter if it is in a crowded flow or the only item in the project. The crash happens both when viewing the b-spline node directly and when viewing a node with a b-splne node attached to it.
To make sure that it wasn't something that I was doing wrong (I'm new to Fusion), I tried loading the project file from a Fusion tutorial I found on Lynda.com and had problems there too. The project would load correctly. I could put view load nodes in the viewer, but the program would crash as soon as I put a populated b-spline node (or a node that had b-spline node attached to it) into the viewer.
Other masking modes seem to be okay so far (I haven't checked them all yet), but I can't get b-splines to work.
To make sure that it wasn't something that I was doing wrong (I'm new to Fusion), I tried loading the project file from a Fusion tutorial I found on Lynda.com and had problems there too. The project would load correctly. I could put view load nodes in the viewer, but the program would crash as soon as I put a populated b-spline node (or a node that had b-spline node attached to it) into the viewer.
Other masking modes seem to be okay so far (I haven't checked them all yet), but I can't get b-splines to work.