Page 1 of 1

Bug? Fusion auto-selects Renderer3D Node switching from Edit

PostPosted: Mon Jun 29, 2020 2:31 pm
by italygroup
If I'm in Fusion and have a Merge3D or ImagePlane3D node selected, then click on Edit tab, then go back to Fusion tab, it always changes whatever I had selected to the Renderer3D node. This is frustrating because often I'm trying to check something, then go back and make an adjustment of the settings in the node I had selected. But since Fusion automatically selects the Renderer3D, I have to go find the node I wanted, select it, dig into the inspector menu to get to the setting I was fine-tuning. Is this a bug?

Re: Bug? Fusion auto-selects Renderer3D Node switching from

PostPosted: Mon Jun 29, 2020 5:27 pm
by Okke Verbart
Hi - I just checked and I can confirm your findings. I'm not sure if this is a bug or intentional behaviour, but I suspect it's the former.