Render manager setup problem
Posted: Thu Feb 03, 2022 11:16 pmHi, I installed latest version 17.4.3 on main machine and installed render node on other machines. Shared folders and maped network drive. In the render manager, i see the nodes as being idle, but when i try rendering a comp it fails at the 1st frame. Comp is saved in \fusion, plate is saved in \fusion\plates, render points to \fusion\render.
tried the path option, loader points at comp:\..\fusion\plates\, render points at comp:\..\fusion\render\
no luck.
In the past i had been able to do network rendering and i don't recall it being complicated. Now have been stuck for a few hours on this problem. Tried turning off all antivirus and firewalls, no luck.
Is there something i'm missing, i whent over the check list in the manual, everything seems to be fine..
thanks.
tried the path option, loader points at comp:\..\fusion\plates\, render points at comp:\..\fusion\render\
no luck.
In the past i had been able to do network rendering and i don't recall it being complicated. Now have been stuck for a few hours on this problem. Tried turning off all antivirus and firewalls, no luck.
Is there something i'm missing, i whent over the check list in the manual, everything seems to be fine..
thanks.