[18b4] Tracker issue

According to the v18 manual, Tracker in the Tracker list has three modes (Enabled, Suspended, Disable).
However, clicking does not change the mode. It always remains "Enable".

These commands work fine. This is UI issue.

Code: Select all

Tracker1.Enabled1=1
Tracker1.Enabled1=2
Tracker1.Enabled1=3

In v17 "Suspended" was disabled, why doesn't BMD fix it?

Thanks for the commands, they work fine in the console, I did not know this trick.
Yes, it's very frustrating that BM doesn't fix bugs as annoying as this, and so obvious!

The loss of the suspended state in the trackers surfaced in fu17 - see this thread:

https://www.steakunderwater.com/wesuckl ... php?t=5147

The hack kindly offered by @the bloke when added into @secondman's TrackerPlus macro restores the ability to chose "suspended" using clicks but it's a little more fiddly.

BM have not responded in any way to my request at the end of the first post -

"BM - can you PLEASE PLEASE PLEASE turn it on again and make the white ball status selectable? It was there for a very good reason and hiding it marks yet another small step backwards in degrading a fast usable UI into one that it is near impossible to work with . . . it's bad enough that the 2D tracker hasn't had any development for over a decade, but now it's actively getting worse!"

Yes, I was useing @the bloke tips. But It is even worse in v18.
Adding new buttons would solve the problem, but ...

Yeah this is bothering me since the issue started in 17…
Hopefully this will be fixed soon.

Hopefully this will be fixed soon.

I hope so too. But we already know how BM is, Resolve is getting full of little bugs but that doesn't seem to matter much.

Yes please fix it is a pain.

[Shrinivas Ramani]

Hi Hideki and others

Thanks for the report. This should be fixed with 18.0b5.

Regards
Shrinivas

Fantastic news! Thank you!

And indeed it is fixed. Well done those men!

Awesome, Thank You so very much!