Fusion page not working after switching to edit page
Posted:
Fri Apr 12, 2024 7:50 amby jazzusa
Hello, I had an effect created on a clip in the fusion page, when I jumped to the edit page the effect did not show, then when I went back to the fusion page all the nodes were still there but they simply didn't work. It is as if the fusion page was frozen. Any ideas? Thanks!
Re: Fusion page not working after switching to edit page
Posted:
Fri Apr 12, 2024 2:06 pmby jazzusa
This issue has been solved. For some reason the effect I was applying through a bspline became completely feathered after I moved to the edit page. The spline softness was somehow enhanced. After hours trying to figure out what had happened I finally understood. I'm on a macbookpro m2. Strange.