Blackmagic Forum

Hi,

Please be consistent in the Spline View UI.

Select a keyframe "30" in Spline View and enter a new value "40" in the Time field in the lower right corner. Pressing the Tab key confirms the value but does not actually confirm it.



I need to press Tab twice to get from time field to Value field. The reverse is a single Tab.



Thank you.

Make sure to post this in the Resolve 19 Beta forum.

I agree this behaviour is not consistent with Inspector controls, but it isn't really a bug, as this has always been the way Fusion's spline editor has worked.
You have to press Enter to confirm a change.
Pressing Tab just moves to the next value until you tab through all of the controls, and then it will apply the change.

There are probably four fields (Time, Value, Ease In, Ease Out) in spline view, but only Time it is not confirmed by Tab (but the new number is remain in the field). All fields in Fusion Studio except this one are confirmed with Tab to proceed to the next field. (Auto control advance in UI preference = off )

Time (Tab x 2) --> Ease In (Tab) --> Ease Out (Tab) --> Value (Tab) --> Time ....

This order is also unnatural. I like ..

Time (Tab) --> Value (Tab) --> Ease In (Tab) --> Ease Out (Tab) --> Time ....