Blackmagic Forum

Hi,

so here goes my first bug report, but since i have not much experience with Fusion, there's fair chance that i may have been doing something wrong.

Basically, i am using two monitor setup and i like to work at both screens at once, having viewer with enough space for image on first monitor, and flow graph with properties panel on the other. The problem here is that if i open new floating viewer, and maximize it on one of my monitors, as soon as i switch window focus to anything else, and then go back to Fusion, floating windows jumps back to original tiny size. That's a bit of an annoyance as i have to re-maximize window every time i switch back to Fusion, which happens very often.

a few more bugs / glitches (please excuse me but, is there official bugs@ mail?)

- bspline - adjusting in the viewer - Bum! fusion is gone
- timeline > Three Item Selection (???) > start>cancel - bum! fu is gone
- can't set huge no in Global Range prefs, while IT IS FINALLY ABLE in the comp (hurray support fo TC - but why the loader can't position itself in time properly and automatically, instead we have to do it by hand? )

good job nonetheless and Thank You !