Page 1 of 1
Matching the Camera to a still image
Posted:
Fri Dec 11, 2015 8:49 amby David Alan Smith
Hello,
I've been searching the webs for days, but haven't come across a solution yet.
I would like to match the camera to a image / backplate. Is this possible? The only thing I was able to find are tutorials for camera tracking.
Hoping someone might be able to help out or point me into the right direction.
Thanks,
David
Re: Matching the Camera to a still image
Posted:
Fri Dec 11, 2015 7:27 pmby Rony Soussan
Feed the image into the camera. There is an image tab there that locks the image plane that is created to the camera. You can adjust distance etc..
Is that what you are talking about?
Re: Matching the Camera to a still image
Posted:
Fri Dec 11, 2015 7:33 pmby michael vorberg
Re: Matching the Camera to a still image
Posted:
Sun Dec 20, 2015 7:34 amby David Alan Smith
Michael that sounds like a nice solution, thanks - but I think it's too complicated for everyday use.
I was thinking more of a tool where you pick 2 or 3 axis and the software calculates the camera angle and the like. Modo and C4D have this kind of function... so I was hoping
Re: Matching the Camera to a still image
Posted:
Mon Dec 21, 2015 8:46 pmby michael vorberg
i guess these tools in other software to that from the article but automated
right now there is no such tool in fusion
Re: Matching the Camera to a still image
Posted:
Mon Dec 21, 2015 10:43 pmby Chad Capeland
The inputs are there... could be a fuse or macro. Hmmm...
Re: Matching the Camera to a still image
Posted:
Tue Dec 22, 2015 4:16 pmby Travis Schmiesing
If it is a still then I would probably use Photoshop to help set up the match and then move to Fusion.