Bump map

Hi.
I have already searched in the forum, but there is no answer for this.
I have built a model in Blender and imported in Fusion 8 (not Studio version). I can't pipe a bump map, although I am able to change materials.
I have already tried by exporting from Fusion with .fbxexporter node and reimport. Also have added more subdivisions in Blender.
Any clue?
Thanks

Hi Blanca,

i hope u are in a good situation
If u put on a Material, does it change the color of your mesh ?
I think there is something worng with the uv´s or normal´s in Blender.

Hallo Stefan,
Danke for your answer
You are wright, I think I made something wrong with the unwrapping. After several times exporting with different parameters, I tried with a new UV map and it worked. So it wasn't a problem with Fusion.
I hope everything is going wunderbar there.
Thanks again and best regards,
Blanca