Blackmagic Forum

Hi there!
How would you recommend to distribute the lines of text horizontally with a little offset that each line would have a random horizontal offset?

Is it possible to set up all in one txt+ ?
I tried to use follower but it gives me an offset for characters and they overlap each other at some point or it offsets by words in the transform tab, but couldn't reach the lines only... I'm pretty sure I misuse some settings...
Thanks in advance.

Misusing settings is key to getting the most out of Fusion

Do the horizontal offsets need to move as well?
If you have less than 8 lines you can create this by using tabs for your text.
Every tab can have a seperate value so you'll get variable spacing.

Or if it's just to set it up, you can use Character Level Styling.
Add a CLS modifier, then select every line seperately and then use the alignment slider to adjust the horizontal off-set.