Blackmagic Forum

Hello everyone,

I've tried to run Fusion 8 on systems with dual monitor setup on both KDE Mint & Ubuntu Studio and I get the following message:

Code: Select all

Floating point exception (core dumped)

Is there a specific setting to allow it to run on two monitors?

Note:
Fusion runs normally on a single monitor.

Thanks in advance!

Actually, allow me to correct the above.

Fusion produces the error when connected to a screen through HDMI alone. I tried it with a single monitor on that connection and the issue remains the same. However, once the connection is DVI, then the program runs normally.