Blackmagic Forum

Intel Core i7-3630QM – 4,.40GHz Windows 10

When I open a projet .comp and I want to make change p.e.x. I want to change the picture in the loader knowing that I have a paint node connected to it. What append if I clik
Yes, or no. I did both but couldn’t make it out.

It looks like when you loaded the comp, the video that was originally in your Loader wasn't found (0 frames). When you connected the new footage, Fusion detected that it wasn't the same length as what it already had, and it was asking if you wanted to reset the Trim In, Trim Out, and Hold Frame settings, since they probably wouldn't be valid for the new clip.

This will happen any time you update a Loader with a clip that has a different length. If you had actually had a video or image sequence in the Loader, and you had set custom trim points, then you'd see a difference in behavior depending on which option you chose. If you haven't customized the trims, or like in this case, you didn't actually have footage connected, then you won't see a difference.

In the majority of cases, you should say "Yes."

I thank you very much
Claude