BRAW plays in RAW player but not in Resolve

I have over 1.44TB of RAW files recorded onto the Samsung T5 SSD from the Blackmagic 6K PRO.

Upon playing the files in Resolve the files flickers with Media offline on all the clips.

The strangers thing about this is that the footage plays fine in Blackmagic RAW player and also in camera.

I still have the files on the SSD, and back up up to my NAS.

All files regardless of the medium type (SSD or NAS) plays fine in RAW player.

What gives has I have a lot of important footage on here. My last option will be to SCREEN RECORD EVERY CLIP and loss the option of BRAW. which is going to suck really bad and going to be extremely time consuming to SCREEN RECORD IT CLIPS.

if only the 6K line have Dual card slot recording and not use the useless expensive CFast 2.0 card

I was also successful at playing the file on all 3 Systems I have using BM RAW player and the media offline flickering does not show up.

I will assume that your SSD was formatted correctly (see manual). Try using the clone tool feature in Resolve to copy/backup the files to a different drive. Then see if you can open those copied files in the media pool.

unlike resolve, the player does not show the errors because they are compensated for in the player,
which is of course not possible in an editing program where frame-accurate cutting is a prerequisite.

but that also means that there were dropouts during the recording and you probably
had the warning for this turned off in the camera.

these errors are caused by many factors:
the SSD was not reformatted before recording.
the compression is too low for the type of media and the resolution is too high.
the USB-C cable used is not suitable for the data throughput, or is simply defective.