Decklink Mini Monitor 4K not working...SOLVED

Hello All,

i installed the Decklink Mini Monitor 4K Card .
Getting nothing showing up !

downloaded and installed the software -- " desktop video 12.4.2"
running MacOS ventura 13.0.1
running a hackintosh on hardware --> Z590-plus ASUS motherboard with AMD Radeon RX 580

Tried booting up Ubuntu 22.04 on the same hardware setup
Decklink card does not show up either

The "HDMI UHD TV" shows some kind of signal coming out of the Decklink card-- it says "480i 60HZ "on the TV

i took out the RX580 card, and inserted the decklink card into the main graphics card slot ( that the RX580 works fine) and don't even get a boot up screen.

i checked the BIOS, but don't see anything obvious to change.

Anybody have any suggestions?
I am at a loss here!!

Bill

Screenshot 2023-01-27 at 2.05.01 PM.png (57.47 KiB) Viewed 1132 times

Screenshot 2023-01-27 at 2.13.46 PM.png (53.44 KiB) Viewed 1132 times

Screenshot 2023-01-27 at 2.15.30 PM.png (73.39 KiB) Viewed 1132 times

I had a similar situation during a recent new z790 build. I installed 12.4.2 and the card would not show up in Premiere. I ended up uninstalling and then installing 12.4 and then the card showed up. Might be worth a shot.

That is the fun of running a hackintosh...and why i quit using them. Too much of a hassle figuring out new kernals for new hardware/software all the time. I have better things to do with my time, so i bailed on them.

Update--
i got it to work in Ubuntu--
once the whole driver downloaded from the blackmagic website was installed
once the "dkms" install was finished
the card firmware needed to be updated in Terminal with
"DesktopVideoUpdateTool "

so now Ubuntu recognizes the card
why does a NEW card need to update its firmware during initial install?
bumma

now onto the next step, which is the MacOS install

That is the fun of running a hackintosh...and why i quit using them. Too much of a hassle figuring out new kernals for new hardware/software all the time. I have better things to do with my time, so i bailed on them.

yea, well, it was NOT working in Ubuntu either... sooo... its not MacOS or hackintosh fault so far ...
we shall see

I'll bet it would work in a real Mac...or a PC...that is where they throw their support.

OK
now working in MacOS Ventura hackintosh
I had to run this command to install the BlackmagicIO.kext in the folder
terminal command -->
sudo mv /Library/Application\ Support/Blackmagic\ Design/Blackmagic\ DeckLink/Signed\ Extensions/BlackmagicIO.kext /Library/Extensions

it will ask you to "approve the security" or some sh*t
then approve it and restart

for some reason the regular install does NOT put that kext in the folder
after that, VIOLA!
hackintosh works

In Resolve, go to Preferences and pick the Video I/O tab
and select the Decklink card for your Monitor
DONE

Glad you got it working.
You have more patience with a hackintosh than i did.

Glad you got it working.
You have more patience with a hackintosh than i did.

hahaha
you can ask my wife... patience is not one of my virtues! hahaha
its just desperation .... i have no choice ...
like when your car is broken down in the outback...
fix it ...
or
die!

Thanks for sharing this. I too have a Ventura hac. I am planning to try mini monitor. I assumed it will work out of box.