Fri May 29, 2020 10:24 pm
Hi everyone,
I've just purchased a Decklink Duo 2 Capture card to use it in half duplex for connecting 3 different cameras.
The default full duplex mode is OK. I can capture 2 input signals on SDI 1 and 3 connectors.
But when I change the connectors mapping in Desktop Video Setup to half duplex mode (Connector 1 = SDI 1, Connector 2 = SDI 3, Connector 3 = SDI 2 Connector 4 = SDI 4), there is absolutely no more video input signals detected.
When I switch back to a full duplex mode it works well again.
I'm really disappointed as I really need my 3 cameras as inputs.
What am I doing wrong ?
Thanks in advance for your help
Best regards