Intensity Shuttle USB 3.0 won't start
Posted: Sat Aug 24, 2013 11:05 amHi all,
I recently purchased a Intensity Shuttle USB 3.0. My machine is a x58 based PC that has sufficient resources. The board doesn't have USB 3.0. I then went and purchased the USB4300NS ( http://www.sunix.com.tw/itpd.php?cid=2& ... 4&pid=1461 ) from Sunix which makes use of the Renesas uPD720201 chipset ( Which is one of the required chipsets for USB 3.0 ). I have also plugged in the required SATA power supply, even put it on it's own rail on the modular power supply. This card provides +5V / 900mA (each port).
The problem I sit with is that every time I plug in the Shuttle I get a "This port doesn't have enough power, please select a different hub" and the device status in the Device manager shows "This device cannot start. (Code 10)".
I have switched off all power management on the system and it still will not start. Any suggestions?
Thanks in advance,
Davin Hansen
I recently purchased a Intensity Shuttle USB 3.0. My machine is a x58 based PC that has sufficient resources. The board doesn't have USB 3.0. I then went and purchased the USB4300NS ( http://www.sunix.com.tw/itpd.php?cid=2& ... 4&pid=1461 ) from Sunix which makes use of the Renesas uPD720201 chipset ( Which is one of the required chipsets for USB 3.0 ). I have also plugged in the required SATA power supply, even put it on it's own rail on the modular power supply. This card provides +5V / 900mA (each port).
The problem I sit with is that every time I plug in the Shuttle I get a "This port doesn't have enough power, please select a different hub" and the device status in the Device manager shows "This device cannot start. (Code 10)".
I have switched off all power management on the system and it still will not start. Any suggestions?
Thanks in advance,
Davin Hansen