FCP 7 crashes when loading clip to viewer
Posted: Mon Dec 10, 2012 5:44 pmRunning FCP 7.0.3 on OSX 10.6.8.
Just installed the Intensity Pro I bought a couple of years ago and installation went fine but I have the same problem that was posted back in August. If I open a clip in the viewer and try to play it, instant crash but if I drop it to the timeline and render it and then take it back up into the viewer it works. If I open a SD project, no similar issue at all.
As they say on SNL "Whutzupwithdat" . . .?
Is there an update in the software that corrects this?
thanks in advance!
Craig
Discovered issue . . . this was a wedding shoot and one of the cameras was a new Sony and the frame rate of the clips on that camera were imported at 1908x1080 . . not 1920 x 1080. So issue isn't related to BM.
Just installed the Intensity Pro I bought a couple of years ago and installation went fine but I have the same problem that was posted back in August. If I open a clip in the viewer and try to play it, instant crash but if I drop it to the timeline and render it and then take it back up into the viewer it works. If I open a SD project, no similar issue at all.
As they say on SNL "Whutzupwithdat" . . .?
Is there an update in the software that corrects this?
thanks in advance!
Craig
Discovered issue . . . this was a wedding shoot and one of the cameras was a new Sony and the frame rate of the clips on that camera were imported at 1908x1080 . . not 1920 x 1080. So issue isn't related to BM.