Page 1 of 1

16 Studio b6 Waveforms not working well for multicam

PostPosted: Sun Jul 21, 2019 5:44 am
by George Atanassov

I have sever issues with getting waveforms to work with multicam clips. The waveforms are ok inside the multicam (Open in timeline) but when any change is made inside the multicam then that change never trickles down to the multicam clip's waveform. The computer goes out processing (fan speed increases and so on) but the results are very mixed and often there is not waveform.

Tried on two different MBPr 2017 and iMac 5K 2015 all running 10.14.5.