DRCM Braw behaviour inconsistent

With Clips from a Bmpcc4k Project settings are:
CScience: Camera medata
WB: As shot
CSpace: Blackmagic Design
Gamma: Blackmagic design film
Exposure, temperature, tint: use camera medatada

When I switch in the raw section to "Clip" from "Project Setting" it properly manages the colors. With the same settings.

[Peter Chamberlain]

It’s not clear to me what the issue is.

I'm not understanding either.

If the BRAW setting is managed at project level id down't properly color manages, meanwhile if I switch to clip in the raw section of the color page it properly works. Same settings

I have noticed an unexplained exposure change when switching from Project to Clip in the RAW controls, despite ISO and Exposure being the same for both.

Is that what you're seeing?

I recall seeing this behavior in earlier betas, but it came and went and, eventually, went completely (haven't seen it for months). Not sure what the pre-requisites for it were.

I would look at the Project settings in the preferences, to see if there's something wrong there -- settings inconsistent with braw.

I have noticed an unexplained exposure change when switching from Project to Clip in the RAW controls, despite ISO and Exposure being the same for both.

Is that what you're seeing?

Definitely looks like that.