Inspector>EQ. Too many unnecesary clicks.
Posted: Wed Dec 22, 2021 3:34 pmRequest for Inspector->Equalizer, which should be more workflow friendly.
It is obvious that if we enable a band 1-4, we have the intention to enable the EQ module on inspector (99,9% of the cases).
So, why not to automatically enable inspector's EQ when clicking on "Band 1" to "Band 4", which is turned off by default.
This will save one click on our workflow, and will allow to keep the focus. Does have sense?
But this can be even more straight and click-friendly:
Editing any value on the EQ turns on the EQ and also its respective band.
I.e: Increasing Gain on Band 3 auto enables Band 3, and also enables the EQ module.
So many clicks saved!
It is obvious that if we enable a band 1-4, we have the intention to enable the EQ module on inspector (99,9% of the cases).
So, why not to automatically enable inspector's EQ when clicking on "Band 1" to "Band 4", which is turned off by default.
- Enable EQ from band.png (279.06 KiB) Viewed 299 times
This will save one click on our workflow, and will allow to keep the focus. Does have sense?
But this can be even more straight and click-friendly:
Editing any value on the EQ turns on the EQ and also its respective band.
- Click friendly EQ.jpg (94.93 KiB) Viewed 292 times
I.e: Increasing Gain on Band 3 auto enables Band 3, and also enables the EQ module.
So many clicks saved!