Allow different output blanking aspect ratios on timeline

Often times the project wants to be able to have clips that are of different aspect ratios. The most common examples are widescreen 2.35:1 with period flashbacks display in 1.33:1. I like to request a feature where I can set different in/out marks and then select an Aspect Ratio as the output blanking within the marks. I can have many of them as needed.

You can use this DCTL I made, if you want. Throw it on a post-clip group node and cjoose the blanking you want for that group. I use it a lot when I have docs with some 4:3 archival that I want to all have the exact same frame, when the rest of the timeline is a wider aspect ratio. You can use it at clip, group, or timeline level, and it does the crop after size transformations.

CustomAspect.dctl.zip

(964 Bytes) Downloaded 50 times

(To install: unzip and place in your LUTs folder.To use, choose the DCTL OFX and select CustomAspect.)

You can use this DCTL I made, if you want. Throw it on a post-clip group node and cjoose the blanking you want for that group. I use it a lot when I have docs with some 4:3 archival that I want to all have the exact same frame, when the rest of the timeline is a wider aspect ratio. You can use it at clip, group, or timeline level, and it does the crop after size transformations.

CustomAspect.dctl.zip

(To install: unzip and place in your LUTs folder.To use, choose the DCTL OFX and select CustomAspect.)

Thanks Robert. This is terrific. Appreciate you a lot!

Just found out about this...

viewtopic.php?f=21&t=154626

Just found out about this...

viewtopic.php?f=21&t=154626

I didn't know it existed since DVR 15. Thanks for letting us know here. Your DCTL did work out for me so thank you for that as well.