High contrast or thicker border for trackers - Fusion

Can you find it?

I'm sure many of you have experienced this, maybe every single time you add a tracker.

"Where is my tracker?".

There should be some settings in the inspector so we can 

By default, in my opinion, the tracker should be super visible when one is added. 
And it should, maybe, always pop up in the same region. When two are added, they will just be next to each other instead of being on top of each other.

There was never a time when I didn't have to "find" the tracker. It can be less than one sec, to 2-3 (it adds up over time to painful long minutes, even hours if you do that for months and months).

Then you try to grab and move it, but you clicked 1 pixel off the hit box, so you try again.

You have to add another tracker, and it's the same story, again, and again... and again.

There are many things that could be changed. The bounding box could be 3-5 pixels larger, and when clicked, while moving it, it would revert back to the tine lines, then when you release it, it would go back to the high contrast/thick visible lines.