- Posts: 1
- Joined: Fri May 17, 2024 7:45 am
- Real Name: Dave Stevens
Fri May 17, 2024 7:52 am
Is there any way to keep the Blackmagic Design HyperDeck Studio HD Plus recording to SD card when it loses a signal?
I was hoping it would act as an ISO recorder for slides at an event yesterday but the cable for the laptop was accidentally pulled out by a speaker. It was put back in and the signal came back but the recording had stopped. Is there anyway to keep it recording or start again when it gets the signal back? I tried swapping the record trigger and timecode options but it didn't help. Would adding in a Timecode generator be the solution to this?
I was hoping it would act as an ISO recorder for slides at an event yesterday but the cable for the laptop was accidentally pulled out by a speaker. It was put back in and the signal came back but the recording had stopped. Is there anyway to keep it recording or start again when it gets the signal back? I tried swapping the record trigger and timecode options but it didn't help. Would adding in a Timecode generator be the solution to this?