XKEYS - JustMacros - ATEM 8.10.1 maximum

Hello, from firmware ATEM 9.xx JustMacros no longer detects the ATEM so the software does not work ... while with firmware 8.10.1 it is the last OK

you need new version of JUST MACROS I think ..

No more version since 2016....

That is the problem ..

The ATEM software also needed to be updated on the computer running the JustMacros software. This caught me once, so now I remember it.

I'm pretty sure my JM is working, and I am running ver 9.x -- that is on the task list to get all computers and switchers at common version.

Hello, for the ATEM software to work with the mixer, it must be the same version. But I'm talking about JustMacros, on my PCwhen I install ATEM 9.xx, I can control the mixer with the ATEM software but the JustMAcros software no longer detects the ATEM... there's no solution!

Hmm...slept since I dealt with this. Try installing the ver 9.x SDK