Run macro on boot?

Questions about ATEM Switchers, Camera Converter and everything live!
  • Author
  • Message
Offline

bcrotaz

  • Posts: 7
  • Joined: Sat Sep 12, 2020 3:25 pm
  • Real Name: Bryan Crotaz

Run macro on boot?

PostThu Jun 08, 2023 12:34 pm

I'm using an Atem (TV Studio and Constellation 1ME) as a headless scaler.
The UI doesn't allow pixel accurate setup of the Upstream Key DVE, but I can tweak it in a macro in xml.

Is there a way to set the ATEM up to run a macro when it starts up?
Offline

codedeltajames

  • Posts: 295
  • Joined: Mon Mar 02, 2020 11:30 am
  • Location: UK
  • Real Name: James Goodwin

Re: Run macro on boot?

PostThu Jun 08, 2023 12:53 pm

No there isn't - however saving the startup state should bring the switcher back to the exact same state after power on, so if you set the DVE settings, tweak it with your macro, then save the startup state (and wait 60s), you shouldn't need to run your macro again.

Return to Live Production

Who is online

Users browsing this forum: No registered users and 48 guests