ATEM Refence

Hi,

Is there a table to show compatible refence signals for different video formats for the ATEMs, or is it a case that they only work with a refence signal that matches the frame rate?

For example I would like to know if it is possible to feed the ATEM a 1080i50 refence signal, but set the ATEM to be 1080p50.

Specifically I am looking at the ATEM Constellation 2 M/E, but would also like to know if this is possible on the old ATEM Television Studios.

Thanks
Seb

[Gary Adams]

On ATEM for p50, p59.94 and p60 use 1080i50, 59.94 or 60 respectively. You could also use black burst of the same rate but tri level is a better reference. This applies to both HD and UHD signals. I hope this helps.

Gary