Page 1 of 1

URSA Mini 4k disable auto focus sqaure

PostPosted: Fri Oct 04, 2019 8:02 am
by SeriousM4x
We are using 3 of the URSA Mini 4k on live events. We remote control them with the ATEM Prod. 4k over SDI.
As soon as we press the auto focus button in ATEMs software control panel the camera focuses, but also shows the white focus square on the SDI output, which is sent to the livestream.
Is there any way to only show the focus square on the camera screen and not output it via SDI?

Re: URSA Mini 4k disable auto focus sqaure

PostPosted: Wed Oct 09, 2019 2:03 pm
by Xtreemtec
Then your rear output is not set to CLEAN FEED ;)

Re: URSA Mini 4k disable auto focus sqaure

PostPosted: Thu Oct 10, 2019 2:57 am
by Tim Schumann
Yep Main SDI needs to be set to Clean Feed: 'On'

Re: URSA Mini 4k disable auto focus sqaure

PostPosted: Wed Oct 23, 2019 9:32 am
by SeriousM4x
Thanks guys! That worked. Thought I had it turned on..

Another question: Can I view the program feed on the cameras lcd screen and at the same time the cameras output on the studio viewfinder?

Re: URSA Mini 4k disable auto focus sqaure

PostPosted: Wed Oct 23, 2019 10:05 am
by Xtreemtec
No, Unfortnatly at this point the LCD and front SDI switch both at the same time. You can not separate them. While that would be a good feature. #Tim? :)

Re: URSA Mini 4k disable auto focus sqaure

PostPosted: Wed Oct 30, 2019 5:05 am
by Tim Schumann
Will add it to the very long list of feature requests.