ATEM Mini suggestion for v2
Posted: Tue Dec 17, 2019 5:39 pmI want to monitor audio out directly from the ATEM Mini. Suggest building in onboard audio extraction out with a 3.5mm jack.
Blackmagic Forum
https://forum.blackmagicdesign.com/
ATEM Mini suggestion for v2
https://forum.blackmagicdesign.com/viewtopic.php?f=4&t=104452
Page 1 of 1
Posted: Tue Dec 17, 2019 5:39 pmRe: ATEM Mini suggestion for v2
Posted: Fri Dec 27, 2019 11:00 amyou can use a $10 hdmi audio extraction device...
Re: ATEM Mini suggestion for v2
Posted: Wed Jan 15, 2020 7:15 amThank you for the suggestion. Yes, I use this $70 audio extractor.
https://www.bhphotovideo.com/c/product/1385810-REG/comprehensive_cpa_hda3_4k_18g_hdmi_audio.html
So, I have had to add the Up Down Cross converter to output 1080i59.94 and 720p59.94, and an audio extractor. Aside from the cost, what could be a very simple HDMI i/o setup now consists of three devices, power supplies and connecting cables.
My suggestion would be to increase the standards/resolution capacity of the Mini ATEM and add a 3.5 mm program audio out jack.
https://www.bhphotovideo.com/c/product/1385810-REG/comprehensive_cpa_hda3_4k_18g_hdmi_audio.html
So, I have had to add the Up Down Cross converter to output 1080i59.94 and 720p59.94, and an audio extractor. Aside from the cost, what could be a very simple HDMI i/o setup now consists of three devices, power supplies and connecting cables.
My suggestion would be to increase the standards/resolution capacity of the Mini ATEM and add a 3.5 mm program audio out jack.
Re: ATEM Mini suggestion for v2
Posted: Wed Jan 15, 2020 12:04 pmbluesgeek wrote:I want to monitor audio out directly from the ATEM Mini. Suggest building in onboard audio extraction out with a 3.5mm jack.
+1
The Atem Mini really should have a TRS headphone output.
Ideally low latency line input 1.