brediknight wrote:Sometimes it just says no ATEM found. Sometimes it Sees it by name and says "Please plug in". huh?
3. What is the default IP ?
4. Is there a factory reset?
It appears you need to have the network setup in order to setup the network. wha?
I too am finding myself quite confused and frustrated by related issues (when trying to use ethernet).
I have been connecting effortlessly and 100% via a USB-C cable between my macbook pro and our ATEM Mini Pro ISO (AMPI). This is our portable, remote setup.
We also use an ATEM TV Studio Pro 4K -- our installation switcher in the Worship Center.
(My Mac has the memory of the Studio Pro 4K from prior connection via the Streaming Bridge.)
So, here's what I was trying to solve:
- The Mini almost-Pro ISO has only one USB-C output, so I can choose to connect my Mac OR to record to external SSD. Not a big limitation, but I wanted to connect my Mac concurrently with the SSD via the Ethernet port on the AMPI.
- So, I have tried this 2 ways -- both fails: 1. Simply connecting an ethernet cable to my Macbook Pro. 2. Connecting via the Streaming Bridge via AMPI: Ethernet Out to Streaming Bridge, and SB USB-C output to MBP.
(Notice that the AMPI ethernet out is labeled "ATEM CONTROL", and the Streaming Bridge USB out is labeled "USB ATEM UTILITY". Surely those indicate that either or both these approaches should work. (And my memory is that one or both previously did work).
- To try to help the Software Control see the AMPI through the S.B., I copied my MBP Manual IP address. This causes the Software Control to see the installation Studio Pro 4K on the church network. But it doesn't see the physically connected AMPI! It just always says "No Switcher Connected".
Here's where I'm at:
- Neither ethernet approach worked.
- In the ATEM Setup, the former Studio Pro 4K always shows up, and the newer Streaming Bridge shows up when phyically connected. The AMPI does NOT! It doesn't show up automatically when disconnected. It does not show up when connected either way (above) via ethernet. It only shows up with a direct USB-C connection.
- When I press "+" in the ATEM Setup to ADD a new device, it asks for an IP Address. How can I know what the internal IP address is of the AMPI? So, I have tried: Open Network Prefs>Advanced>Select our WIFI>TCP-IP tab>IP V4 address, which is: 192.168.30.54. So, I copy this. Result: No ATEM Found. I have also tried changing the final number. Same result: No ATEM Found.
Can someone guide me:
How can I control via software the ATEM Mini Pro Iso utilizing the ethernet output -- either directly to MacbookPro or through the Streaming Bridge?