Page 1 of 1
Pinout for Constellation Intercom XLR5
Posted:
Wed Sep 02, 2020 12:38 pmby Robert Betzner
Hi,
does anyone have the pinout of the XLR5 socket on the frontpanel of the Constellation for intercom headsets?
I didn't find anything in the manual so far.
Thanks and cheers
Robert
Re: Pinout for Constellation Intercom XLR5
Posted:
Wed Sep 02, 2020 12:59 pmby Tom_Bassford
Sent from my iPhone using Tapatalk
Re: Pinout for Constellation Intercom XLR5
Posted:
Wed Sep 02, 2020 2:38 pmby David Hutchinson
Hi Tom - nice to see you still around
Just to confirm Tom's connections I use the Shure BRH440M for the Constellation and here are the pin connections and colours for it.
- Shure Mic connections.png (226.61 KiB) Viewed 3369 times
Re: Pinout for Constellation Intercom XLR5
Posted:
Wed Sep 02, 2020 2:57 pmby Robert Betzner
Fantastic!!!
Thanks so much!
Good to see that there are still some other than ATEM mini users around.
Cheers
Robert
Re: Pinout for Constellation Intercom XLR5
Posted:
Wed Jun 23, 2021 2:51 pmby Ben Doyle
Do you know if I can just use pins 4 and 5 to get a stereo listen headset connected? I really just want to use the talkback jack on the Constellation front to be able to monitor audio with a normal set of headphones. Thanks!
Re: Pinout for Constellation Intercom XLR5
Posted:
Sun Jun 27, 2021 5:13 amby Ben Doyle
Just in case anyone else is curious...the answer is yes. You can use pin 3 for ground, pin 4 for Left and pin 5 for Right. I wired it up to a standard 3.5mm stereo female headphone jack. Works great as a way to monitor audio directly on the Constellation.
Re: Pinout for Constellation Intercom XLR5
Posted:
Mon Apr 22, 2024 1:22 pmby gewuerzwiesel
Does the wiring 3-GND, 4-left and 5-right work for the Television Studio HD8?
I tried it with DT 770 Pro (80 Ohm) but I had no signal.
Using a headset (Superlux HMD685a, 400 Ohm / 100 mW input power), I got very low audio signal when all levels are set to max.
It seems the impedance doesn't match? Is there a workaround or more info Blackmagic which specs are supported?