ATEM Software cutting off buttons on a MacBook Pro 13"

Hi all

I'm trying to set up my ATEM Production Studio 4K with a 2012 MacBook Pro 13". The problem I have is half the ME buttons are cut off, presumably because the resolution of the display is low (1280x800).

Does anyone know a way to 'shrink' the BM GUI so it shows more (smaller buttons for example)?

Thanks a lot,

Jonathan

Unfortunately, I don't think there is a way to resize the ATEM Software Control panel.

There is a note about the minimum monitor resolution required on the ATEM Tech Specs page:
https://www.blackmagicdesign.com/produc ... s/W-APS-04

Interface
Minimum monitor resolution of 1366 x 768.

Use SwitchResX to create a higher virtual resolution.

https://www.madrau.com

Good Luck